Swap USDT to XMRUSDT on ETH → XMR
Exchange Tether (USDT) to Monero (XMR) privately. The rate is locked the moment your order is created, the payout is fixed, and failed swaps are automatically refunded. No account, no KYC, no limits.
Enter an amount on the exchange widget below to see the live locked rate.
Open exchangeUSDT to XMR swap at a glance
| Rate | Locked the moment the order is created — fixed-rate, the payout does not move afterwards. |
|---|---|
| You send | USDT on ETH |
| You receive | XMR on XMR |
| Typical time | 10–30 minutes after your deposit reaches the required confirmations. |
| Limits | Per-pair minimum and maximum are set by the liquidity provider and shown live in the widget. |
| Fees | No spread is added on top of the provider rate — we are paid by the provider, not by you. |
| Account | None. No email, no password, no KYC — you need a receiving address and nothing else. |
How to swap USDT to XMR (USDT on ETH → XMR)
- 1. Choose USDT as what you send and XMR as what you receive.
- 2. Paste your XMR receiving address and create the order — the rate locks instantly.
- 3. Send USDT to the one-time deposit address shown.
- 4. After network confirmations, XMR arrives at your address. Track every step on the order page.
Exchange widget
You send
You receive
—
About Tether (USDT)
The dollar rail of crypto — the most common entry asset for privacy swaps.
- · USDT exists natively on Tron (TRC20), Ethereum (ERC20), Solana, TON and many more — the network suffix in a swap order matters more than the ticker.
- · TRC20 is the cheapest rail (cents per transfer); ERC20 is the most established but gas-priced. Pick the one your balance actually sits on.
- · Tether freezes addresses on public request — the USDT leg of any swap is fully legible to the issuer. Privacy starts at the coin you receive.
About Monero (XMR)
The privacy coin by default — every transaction is private, with no opt-in needed.
- · Private by default: ring signatures hide the sender, stealth addresses hide the receiver, RingCT hides the amount. No 'transparent mode' to accidentally use.
- · Confirmed in ~2 minutes on average (10 confirmations ≈ 20 min for full settlement), fees typically under $0.01 regardless of amount.
- · Uniformly opaque ledger means no chain-analysis shortcuts — the reason KYC exchanges delist it and no-KYC swap services became its main liquidity channel.
Related guides
Both directions are supported
| USDT → XMR | This page |
| XMR → USDT | Open |
Frequently asked questions
- Do I need KYC or an account to swap USDT to XMR?
- No. There is no account, no email and no identity check — you paste a receiving address and send.
- How long does a USDT to XMR swap take?
- Usually 10–30 minutes, counted from the moment your deposit reaches the required confirmations.
- Does the rate change after I create the order?
- No. This pair uses fixed-rate: the payout is locked at order creation and does not move afterwards.
- What is the minimum amount?
- It is set per pair by the liquidity provider and shown live in the widget above — the quote returns an error with the exact minimum if you go under it.
- What happens if I send less than the quoted amount?
- Underpaid orders are refunded to the refund address you provide, once the provider confirms the shortfall.
- Do you hold my coins at any point?
- No. Your deposit goes to a one-time address at a third-party liquidity provider, not to a VeilSwap wallet.
- Where does the rate come from?
- From third-party liquidity providers. We compare quotes per pair and route to the one that pays out the most.
- Can I swap XMR back to USDT?
- Yes — both directions are live and use the same fixed-rate order flow. The reverse page is linked below.
- Can I use VeilSwap over Tor?
- Yes. An onion mirror serves the same application — same quotes, same order flow, not a reduced copy.
- What if the swap fails?
- You are refunded automatically to the refund address you entered, once the provider reports the failure.